--- 1/draft-ietf-lamps-ocsp-nonce-04.txt 2020-09-10 11:13:09.779339093 -0700 +++ 2/draft-ietf-lamps-ocsp-nonce-05.txt 2020-09-10 11:13:09.795339496 -0700 @@ -1,205 +1,193 @@ LAMPS M. Sahni, Ed. Internet-Draft Palo Alto Networks -Updates: 6960 (if approved) September 2, 2020 +Updates: 6960 (if approved) September 10, 2020 Intended status: Standards Track -Expires: March 6, 2021 +Expires: March 14, 2021 OCSP Nonce Extension - draft-ietf-lamps-ocsp-nonce-04 + draft-ietf-lamps-ocsp-nonce-05 Abstract This document specifies the updated format of the Nonce extension in - Online Certificate Status Protocol (OCSP) request and response + the Online Certificate Status Protocol (OCSP) request and response messages. OCSP is used to check the status of a certificate and the - Nonce extension is used in the OCSP request and response messages to - avoid replay attacks. This document updates the RFC 6960. + Nonce extension is used to cryptographically bind an OCSP response + message to a particular OCSP request message. This document updates + RFC 6960. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." - This Internet-Draft will expire on March 6, 2021. + This Internet-Draft will expire on March 14, 2021. Copyright Notice Copyright (c) 2020 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1. Terminology . . . . . . . . . . . . . . . . . . . . . . . 2 - 2. OCSP Extensions . . . . . . . . . . . . . . . . . . . . . . . 3 + 2. OCSP Extensions . . . . . . . . . . . . . . . . . . . . . . . 2 2.1. Nonce Extension . . . . . . . . . . . . . . . . . . . . . 3 - 3. Security Considerations . . . . . . . . . . . . . . . . . . . 4 + 3. Security Considerations . . . . . . . . . . . . . . . . . . . 3 3.1. Replay Attack . . . . . . . . . . . . . . . . . . . . . . 4 3.2. Nonce Collision . . . . . . . . . . . . . . . . . . . . . 4 4. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 - 5. Changes to Appendix B. of RFC 6960 . . . . . . . . . . . . . 5 - 5.1. Changes to Appendix B.1. OCSP in ASN.1 - 1998 Syntax . . 5 + 5. Changes to Appendix B. of RFC 6960 . . . . . . . . . . . . . 4 + 5.1. Changes to Appendix B.1. OCSP in ASN.1 - 1998 Syntax . . 4 5.2. Changes to Appendix B.2 OCSP in ASN.1 - 2008 Syntax . . . 5 6. References . . . . . . . . . . . . . . . . . . . . . . . . . 5 6.1. Normative References . . . . . . . . . . . . . . . . . . 5 - 6.2. Informative References . . . . . . . . . . . . . . . . . 6 + 6.2. Informative References . . . . . . . . . . . . . . . . . 5 Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction This document updates the usage and format of the Nonce extension used in OCSP request and response messages. This extension was - previously defined in section 4.4.1 of [RFC6960]. The [RFC6960] does - not mention any minimum and maximum length of the nonce extension. - Due to not having an upper or lower limit of the length of the Nonce - extension, the OCSP responders that follow [RFC6960] may be - vulnerable to various attacks like Denial of Service attacks - [RFC4732], chosen prefix attacks to get a desired signature from the - OCSP responder and possible evasions that can use the Nonce extension - data for evasion. This document specifies a lower limit of 1 and an - upper limit of 32 to the length of the Nonce extension. This - document updates the [RFC6960]. + previously defined in section 4.4.1 of [RFC6960]. [RFC6960] does not + mention any minimum and maximum length of nonce in the Nonce + extension. Lacking limits on the length of nonce in the Nonce + extension, an OCSP responders that follow [RFC6960] may be vulnerable + to various attacks like Denial of Service attacks [RFC4732], chosen + prefix attacks to get a desired signature, and possible evasions + using the Nonce extension data. This document specifies a lower + limit of 1 and an upper limit of 32 to the length of nonce in the + Nonce extension. This document updates [RFC6960]. 1.1. Terminology The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here. 2. OCSP Extensions - The message format for the OCSP request and response is defined in - the [RFC6960]. [RFC6960] also defines the standard extensions for - OCSP messages based on the extension model employed in X.509 version - 3 certificates (see [RFC5280]). The following is a list of standard - extensions that can be used in the OCSP messages by the OCSP - responder and OCSP client. - - * Nonce - * CRL References - * Acceptable Response Types - * Archive Cutoff - * CRL Entry Extensions - * Service Locator - * Preferred Signature Algorithms - * Extended Response Definition - - This document only specifies the new format for Nonce extension and - does not change the specification of any of the other standard - extensions. + The message format for OCSP request and response is defined in + [RFC6960]. [RFC6960] also defines the standard extensions for OCSP + messages based on the extension model employed in X.509 version 3 + certificates (see [RFC5280]). This document only specifies the new + format for Nonce extension and does not change specification of any + of the other standard extensions defined in [RFC6960]. 2.1. Nonce Extension This section replaces the entirety of the Section 4.4.1 of [RFC6960] which describes the OCSP Nonce extension. The nonce cryptographically binds a request and a response to prevent replay attacks. The nonce is included as one of the requestExtensions in requests, while in responses it would be included as one of the responseExtensions. In both the request and the response, the nonce will be identified by the object identifier id-pkix-ocsp-nonce, while the extnValue is the value of the nonce. If Nonce extension is present then the length of nonce MUST be at least 1 octet and can be up to 32 octets. - A server MUST reject any OCSP request having a Nonce extension with - length of 0 octets or more than 32 octets with the malformedRequest - OCSPResponseStatus as described in section 4.2.1 of [RFC6960]. + A server MUST reject any OCSP request having a nonce in the Nonce + extension with length of 0 octets or more than 32 octets with the + malformedRequest OCSPResponseStatus as described in section 4.2.1 of + [RFC6960]. The value of the nonce MUST be generated using a cryptographically - strong pseudorandom number generator (see [RFC4086]). The OCSP - clients SHOULD use a length of 32 octets for the Nonce extension. - The minimum nonce length of 1 octet is defined to provide the - backward compatibility with older clients following [RFC6960] - however, the newer OCSP clients MUST use a length of at least 16 - octets for Nonce extension. The OCSP responder MAY choose to ignore - Nonce extension for the requests where length of the Nonce extension - is less than 16 octets. + strong pseudorandom number generator (see [RFC4086]). The minimum + nonce length of 1 octet is defined to provide backward compatibility + with older clients that follow [RFC6960]. Newer OCSP clients that + support this document MUST use a length of 32 octets for the nonce in + Nonce extension. OCSP responders MUST accept lengths of at least 16 + octets, and MAY choose to ignore the Nonce extension for requests + where the length of the nonce is less than 16 octets id-pkix-ocsp OBJECT IDENTIFIER ::= { id-ad-ocsp } id-pkix-ocsp-nonce OBJECT IDENTIFIER ::= { id-pkix-ocsp 2 } Nonce ::= OCTET STRING(SIZE(1..32)) 3. Security Considerations - The security considerations of OCSP, in general, are described in the - [RFC6960]. The Nonce extension is used to avoid replay attacks - during the interval in which the previous OCSP response for a - certificate is not expired but the responder has a changed status for - that certificate. Including client's Nonce value in the OCSP - response makes sure that the response is the latest response from the - server and not an old copy. + The security considerations of OCSP, in general, are described in + [RFC6960]. During the interval in which the previous OCSP response + for a certificate is not expired but the responder has a changed + status for that certificate, a copy of that OCSP response can be used + to indicate that the status of the certificate is still valid. + Including client's Nonce value in the OCSP response makes sure that + the response is the latest response from the server and not an old + copy. 3.1. Replay Attack The Nonce extension is used to avoid replay attacks. Since the OCSP responder may choose to not send the Nonce extension in the OCSP response even if the client has sent the Nonce extension in the request [RFC5019], an on-path attacker can intercept the OCSP request and respond with an earlier response from the server without the Nonce extension. This can be mitigated by configuring the server to - use a short time interval between thisUpdate and nextUpdate fields in - the OCSP response. + use a short time interval between the thisUpdate and nextUpdate + fields in the OCSP response. 3.2. Nonce Collision - If the value of the nonce used by a client in OCSP request is not - random enough, then an attacker may prefetch responses with the + If the value of nonce used by a client in OCSP request is + predictable, then an attacker may prefetch responses with the predicted nonce and can replay them, thus defeating the purpose of using nonce. Therefore the value of Nonce extension in the OCSP request MUST contain cryptographically strong randomness and MUST be freshly generated at the time of creating the OCSP request. Also if - the length of the nonce extension is too small e.g. 1 octet then an - on-path attacker can prefetch responses with all the possible values - of the nonce and replay a matching nonce. + the length of nonce is too small e.g. 1 octet then an on-path + attacker can prefetch responses with all the possible values of nonce + and replay a matching nonce. 4. IANA Considerations This document does not call for any IANA actions. 5. Changes to Appendix B. of RFC 6960 This section updates the ASN.1 definitions of the OCSP Nonce - extension in the Appendix B.1 and Appendix B.2 of the [RFC6960] The + extension in Appendix B.1 and Appendix B.2 of [RFC6960] The Appendix B.1 defines OCSP using ASN.1 - 1998 Syntax and Appendix B.2 defines OCSP using ASN.1 - 2008 Syntax 5.1. Changes to Appendix B.1. OCSP in ASN.1 - 1998 Syntax OLD Syntax: - The definition of OCSP Nonce Extension is not provided in the + The definition of OCSP Nonce Extension is not provided in Appendix B.1 of [RFC6960] for the ASN.1 - 1998 Syntax. NEW Syntax: Nonce ::= OCTET STRING(SIZE(1..32)) 5.2. Changes to Appendix B.2 OCSP in ASN.1 - 2008 Syntax OLD Syntax: